These are 1.0 mm thick flat visors made to fit the AGV Ago and X3000/80 helmets from the 1980's that had pivot fittings that require to be unscrewed to fit or remove the visor.This screw top fixed type helmet could be considered as the MK1 helmet. This was the very first X3000 helmet and there are later versions with different visors - so please check before purchasing that you are ordering the correct part. IF in any doubt please contact us for assistance.
The slightly later version of these helmets also made in the 1980's were made so that the visor simply clips over the pivot fittings to retain them in position on the helmet. The visor on the clip over type helmets is longer in length and this BHV002 visor WILL NOT fit the clip over fixing type helmet - these helmets require our visor part number BHV54.
THESE VISORS DO NOT FIT THE NEW 2017 ONWARDS AGV X3000 'LEGENDS' LEG-1 HELMETS WITH 3D BUBBLE SHAPE VISORS.
The visors are BSI approved and fully U.K. road legal. They give 97 % U.V. light protection. The smoke tint visors have a light transmission of 50%
Made in the U.K. by Bob Heath visors Ltd from Lexan polycarbonate, these visors have an abrasion resistant coating on both sides.
Tinted visors are recommended for daytime use only and are stamped as such as per the BSI standard requirement.
The visors are available in clear and light tint smoke options . Please select which option you require from the drop down list.
These visors measure 31.4 cms between the inside edges of the pivot screw hole slots, and 23.0 cms between the inside edges of the lower stud slots.
They are 1.0 mm flat visors that are secured in place via the two top edge slots that the screw fittings of your helmet fix through, and the two bottom edge press studs that fix onto the studs on your helmet.
As there are now 3 different AGV X3000 helmets it is most important that you check the measurements above if you are not 100% sure which model you have.